Publicité
Les langues disponibles
Les langues disponibles
• Before each use, check that the appliance is in good condition and that the power cord is
not damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
To use the fan heater, please follow the instructions below:
1)
Insert the plug in the current socket.
2)
To turn on the appliance, turn the selector knob (B) in the position corresponding at the
function requested.
"0" = off
" ~ " = air warm (1000 W)
3)
The thermostat (A) adjusts the ambient temperature, and is greater when the selector is
turned towards the maximum position (clockwise direction): once the temperature has
been reached, it will be kept constant, while setting it to the lines in between causes the
element to come on at intervals.
- The indicator light (C) turns on and off when the appliance reaches the set temperatures.
- Safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
4)
To turn off the fan heater, please turn the Knob in the "0" position and the thermostat
knob anticlockwise. Then pull out the plug from the socket.
If the appliance is not being used for long periods of time, remove the plug from the plug
point.
CLEANING AND MAINTENANCE
Warning: before cleaning the appliance, turn it off, remove the plug from the plug point and
wait until it cools down.
• To ensure proper operation of the appliance, periodically check that the ventilation grille is
not blocked by fluff or threads: this should be done after removing the plug from the mains;
If necessary, use a vacuum cleaner, taking care not to damage the element.
• To clean the main outer casing using a soft, damp cloth; do not use steel wool or abrasive
products.
• If the fan heater is not used for long period of time, cover it and store it in a dry place; it is
advisable to place it in the original packaging to protect it from dust and moisture.
"
" = fan
" ≈ " = air very hot (2000 W)
12
Publicité
