Spector&Co SPECTECH T1039 Mode D'emploi page 3

1) ON: Press once
2) OFF: Press
NOTE: The T1039 will automatically power OFF when inactive for approx. 60 seconds.
To Recharge T1039
a) Via Micro-USB charging cable
1. Insert the micro-USB output of the charging cable into the T1039 & connect USB output to a
power supply (wall adapter with DC 5V output – not included).
2. A solid red & flashing blue LED lights will appear while charging. Once the T1039 is 100% fully
re-charged, the blue LED will remain solid.
b) Via Type-C output charging cable (not included)
1. Insert the Type-C output of the charging cable into the T1039 & connect USB output to a power
supply (wall adapter with DC 5V output – not included).
2. A solid red & flashing blue LED lights will appear while charging. Once the T1039 is 100% fully
re-charged, the blue LED will remain solid.
To wirelessly charge an electronic device using the T1039
** Make sure your device has integrated wireless charging capability or is equipped with wireless
charging adapter (NOTE: some electronic devices with integrated wireless capability may require users
to manually enable wireless charging in the settings of their electronic devices)
1) Center your electronic device on top of suction cup pad (see # 6 of Product Map above). One
flashing green & blue LED indicates the T1039 is wirelessly charging your electronic device (NOTE:
the blue & green LED lights will remain lit while charging your device & once your device is fully
charged.
2) To stop charging, press
To charge electronic devices using the T1039 with charging cable
1) Insert the following cable into the T1039 USB output:
a. To charge Android devices: use the micro-USB/USB cable included with the T1039.
b. To charge IOS devices: use the certified charging cable accessory that came with your
smart phone/electronic device.
2) Turn the power bank ON (press
twice
button twice & remove your electronic device from suction cup pad.
once). Blue, Red & Green LED lights will be lit.