Touch Control - Klarstein MARIANA NEO Mode D'emploi

EN
26

TOUCH CONTROL

After plug in power, will into Stand By mode automatic.
On/Off button: It is used for turning on/off the fan.
FAN SPEED key: Button for changing the speed of motor following cycle "Low-Middle-
Hight-Low".
Light button
Short press for lamp power control.
Kelvin adjustable function . under standy /working state .Long press
value, under kelvin adjustable state, LCD display shows current kelvin value(kelvin value
from E1-E6; brightness value from L1-L3).
Can be adjusted kelvin value by long press
adjusted button brightness by short press adjusted button brightness by short press
press , then current Kelvin value is set successfully.
Timer button
1. In STANDBY MODE, long press to enter the TIME SETTING MODE. Hour display In STANDBY MODE, long press to enter the TIME SETTING MODE. Hour display In STANDBY MODE, long press to enter the TIME SETTING MODE. Hour display
fl ashing, press or
fl ashing, press or
In this state: press
hood, pre-set cycle : OFF → 15mins → 30mins → 45mins → 60mins.
2. Short press during working mode to programme a COUNTDOWN TIME for the
3. Under COUNTDOWN TIME state, you can use
short press to change 1 minute,long press for continuous change.
4. After 5 seconds(without using any operating buttons) the countdown starts. The
indicator of the TIMER remains on.
5. When time up, both motor & light will turn off automatically & come back to
STANDBY MODE.
FAN SPEED button + LIGHT button :
1. When motor is working, long press
function, after 5 minutes motor & light will turn off automatically.
2. For turning off the "Cleaning symbol" & reset total working time when "Cleanning
symbol" is on & motor or lamp is on.
For checking current total working time when "Cleaning symbol" is off.
brightness by short press button, and
button once Kelvin value is selected, long
for setting. Once hours are setted, minutes display for setting. Once hours are setted, minutes display
for setting.
key for decrease. Press
& at the same time to enter quick timer
to adjust Kelvin
key for increase.
or to change the time,