Campbell Hausfeld PW167600AV Instructions D'utilisation Et Manuel De Pièces page 4

Electric High Pressure Washer
Setup and Operating
Instructions
THINGS TO REMEMBER
1. Always check the inlet filter for
debris.
2. Always reset the Ground Circuit
Interrupter (GFCI) each time the
unit is plugged into an outlet.
3. Never direct a single point spray at
a soft or breakable surface.
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fit-
ting on the unit.
2. Attach quick connect to garden
hose.
3. Pull side "A" of quick connect
toward garden hose and push onto
nipple adapter.
4. Push side "A" of quick connect
towards nipple adapter and release.
"A"
Figure 10
SYSTEM CONNECTION
1. Ensure that the power switch is in
the OFF position.
2. Attach high pressure hose and gun
assembly to the unit.
3. Insert lance into the gun and turn
clockwise to positive stop as shown
in Figure 11.
Figure 11
4. Connect garden hose as explained
in the Garden Hose Connection
Instructions.
5. Plug the power cord into a ground-
ed outlet and press the reset button
on the GFCI as shown in Figure 12.
THIS MUST BE DONE EACH TIME
THE UNIT IS PLUGGED INTO AN
OUTLET.
Reset
Figure 12
6. Turn the water on.
7. Trigger the gun for 1 minute to
release pressure and to remove any
air trapped in the system.
8. Turn the OFF/ON switch to the ON
position.
The pressure washer is now ready
to use on your cleaning application.
Please refer to Figure 13 for nozzle
fan adjustment.
Rotating the nozzle will vary the
spray pattern from approximately a
0 o stream to a 60 o fan spray.
NOTE: The Turbo Lance is NOT
adjustable and cannot be used to
apply detergent.
Figure 13
DETERGENT APPLICATION
1. Remove the cap from the detergent
tank and pour in UNDILUTED pres-
sure washer detergent. Replace cap.
2. Turn the OFF/ON switch to the ON
position.
4
3. Slide nozzle to the low pressure
position as shown in Figure 14 and
apply detergent.
IMPORTANT: Unit will only apply
detergent when adjustable nozzle is
used and the nozzle is in the low
pressure position.
LOW PRESSURE
HIGH PRESSURE
Figure 14
4. To rinse or return to high pressure,
release the trigger and slide the
nozzle to the high pressure position.
NEVER SLIDE THE NOZZLE FROM
LOW TO HIGH OR HIGH TO LOW
PRESSURE WHEN THE GUN IS TRIG-
GERED.
Maintenance
1. Never store unit outdoors or where
it could freeze.
2. LONG STORAGE PERIODS: When
the unit is stored for more than 2
months, run a mixture of 50%
antifreeze and water through the
pump as follows:
--Remove the high pressure hose
and garden hose from the pump.
--Tilt the unit on its side and turn
the OFF/ON switch to the ON
position.
--Pour 1 cup of the 50% antifreeze
and water mixture into the inlet
side of the pump.
--Turn the unit OFF. It is now ready
for storage.