Auto Operation Setting - Danby DPA080CB7WDB Instructions

How to use the Buttons
TEMP (°C / °F)
2
1
TEMP (°C / °F)
2
1
Auto Operation
Ensure that the unit is plugged in and has power. The OPERA-
TION indicator will illuminate on the display panel of the unit.
1. Press the MODE button until AUTO is selected.
2. Press the TEMP button to set the desired temperature. The
temperature can be set within a range of 17°C (62 °F) to 30°C
(86°F) by 1°C (1°F) increments.
3. Press the
3
NOTE
1. In auto mode, the air conditioner can automatically choose
the mode of Cooling, Fan, Dehumidifying by sensing the differ-
ence between the actual room temperature and the set tem-
perature on the remote control.
2. In auto mode, you can't switch the fan speed.
3. If auto mode doesn't suit you, the desired mode can be con-
trolled manually.
Cooling / Fan Operation
Ensure the unit is plugged in and has power.
1. Press the MODE button to select COOL, FAN mode.
2. Press the TEMP button to set the desired temperature. The
temperature can be set within a range of 17°C (62°F) to 30°C
(86°F) in 1°C (1°F) increments.
3. Press the
Low, Med, or High.
4. Press the
NOTE
4
In FAN mode, the temperature setting is not displayed on the re-
3
mote control and you are not able to control the room tempera-
ture either. In this case, only step 1, 3, and 4 may be performed.
7
button to start the air conditioner.
button to select one of the 4 fan speeds, Auto,
button to start the air conditioner.