Handling The Remote Control - Danby DPA080CB7WDB Instructions

Handling the Remote Control

•
The air conditioner will not respond if curtains, doors or other materials block the signal from the
remote control to the unit.
•
Prevent any liquid from contact with the remote control. Do not expose the remote control to direct
sunlight or heat.
•
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner
may not function properly. Use curtains to prevent the sunlight from falling on the receiver.
•
If other electrical appliances react to the remote control, either move these appliances to another
location or consult your local dealer.
Replacing the Batteries
• Use the remote control within a distance of 8 m (26 ft.) from
the appliance, pointing it towards the receiver. Reception is
confi rmed by a beep.
CAUTION
The remote control is powered by two dry batteries (2-AAA)
located in the rear part and protected by a cover.
1. Remove the cover by pressing down and sliding it off.
2. Remove the old batteries and insert the new batteries,
placing the (+) and (-) ends correctly.
3. Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote control
erases all programming. After inserting new batteries, the
remote control must be reprogrammed.
.
2