Function Buttons - Danby DPA080CB7WDB Instructions

Function Buttons

TEMP (°C / °F)
1
3
4
5
Model: RG5 1 4 I
1.
2.
2
6
7 3. MODE Button: Each time the button is pressed, the opera-
8
9
10
11
12
4.
6 B / G C E
5.
6.
7.
8.
9.
TEMP DOWN Button: Push this button to decrease
the indoor temperature setting by 1°C (1°F) increments to
17°C (62°F).
TEMP UP Button: Push this button to increase the
indoor temperature setting by 1°C (1°F) increments to 30°C
(86°F). Press and hold the UP and DOWN buttons at the
same time for 3 seconds to alternate the temperature dis-
play between °C and °F.
tion mode changes in the following sequence:
AUTO COOL
Button: Used to stop or start louver movement and
move the airfl ow direction up/down as desired.
Button: once the recessed RESET button is pressed,
all of the current settings will be cancelled and the control-
ler will return to default settings.
Button: Operation starts when this button is pressed
and stops when the button is pressed again.
Button: Used to select the fan speed in four steps:
Auto Low
Button: Press this button to activate the Auto-on time
setting. Each time it's pressed will increase the start time by
30 minute increments, up to 10 hours, then by 1 hour incre-
ments up to 24 hours. To cancel the Auto-on time setting,
just press the button until the time setting is 0.0.
Button: Select this function if you want the unit to
maintain a comfortable setting and save energy while you
sleep. This function is available on COOL or AUTO mode
only.
4
DRY FAN
Med High