Manually Connecting The Subwoofer; Led Indicator Lights On The Rear Of Subwoofer - Samsung HW-Q900A Mode D'emploi

Manually connecting the Subwoofer

Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer are connected properly.
• Make sure that the Soundbar is turned off.
1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
3. Press the Up button on the remote control for 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when ID SET is complete.
4. Check if the LINK LED is solid blue (connection complete).

LED Indicator Lights on the Rear of Subwoofer

LED
Blue
Red
5 Sec
Rear of Subwoofer
5 Sec
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer.
Blue is On
Status
Successfully connected
On
(normal operation)
Blinking Recovering the connection
Standby (with the
Soundbar main unit turned
off)
On
Connection failed
Rear of Subwoofer
ID SET
Description
-
Check if the power cable attached to the main Soundbar
unit is connected properly or wait about 5 minutes.
If blinking persists, try manually connecting the
subwoofer. See page 14.
Check if the power cable attached to the main Soundbar
unit is connected properly.
Connect again. See the instructions for manual
connection on page 14.
ENG - 14
Blinking
blue fast
Resolution