Setting Temperature And Selecting Modes; Water Dispenser - essentiel b ERAVDE180-90v1 Notice D'utilisation

• SCREEN STANDBY MODE
The display screen goes into standby mode (it is turned off) after 3 minutes if no key is
pressed. To exit standby mode, press any button (the screen lights up) and then press the
"3 sec to unlock" button for 3 seconds. You can then make the setting adjustment(s).
The screen also exits standby mode when you open the door of the appliance.

Setting temperature and selecting modes

• SETTING THE REFRIGERATOR TEMPERATURE
Press the "Temp Zone" button until the refrigerator compartment flashes in the display
(point 3 in the diagram on the previous page). Then press the "Temp" button once or several
times to select a temperature as shown below:
2°C -> 3°C -> 4°C -> 5°C -> 6°C -> 7°C -> 8°C -> OF -> 2°C ...
Each press of the "Temp Zone" button increases the temperature by one degree.
• SETTING THE FREEZER TEMPERATURE
Press the "Temp Zone" button until the freezer compartment flashes in the display (point 2
in the diagram on the previous page). Then press the "Temp" button once or several times
to select a temperature as shown below:
-24°C -> -23°C -> -22°C -> -21°C -> -20°C -> -19°C -> -18°C -> -17°C -> -16°C -> -24°C ...
Each press of the "Temp Zone" button decreases the temperature by one degree.
• "SMART" MODE (INTELLIGENCE)
In "Smart" mode, the refrigerator temperature is automatically set to 5°C and the freezer
temperature is set to -18°C.
To activate this mode, press the "Function" button until the "Smart" mode symbol flashes.
then press the "OK" button to confirm the selection. The
To deactivate "Smart" mode , press the "Function" button until the "Smart" mode symbol
flashes. Then press the "OK" button to exit. The
If you select the "Fast freeze" mode, the "Smart" mode is deactivated.
36
V.1.0
using the appliance
indicator light comes on.
indicator light goes off.
• We recommend setting your refrigerator to "Smart" mode for normal and daily use.
• FAST FREEZE MODE
Select this mode if you intend to freeze a large amount of food. The temperature of the
appliance will drop rapidly to -32°C. The appliance remains at this temperature for 26 hours.
To activate the "Fast freeze"mode, press the "Function" button until the "Fast freeze" mode
symbol flashes. Then press the "OK" button to confirm the selection. The
light comes on.
To deactivate "Fast freeze" mode, press the "Function" button until the "Fast freeze" mode
symbol flashes. Then press the "OK" button to exit. The
After 26 hours of operation, the "Fast freeze" mode stops automatically.
If you select the "Smart" mode, the "Fast freeze" mode is deactivated.
• TEMPERATURE FAULT AUDIBLE SIGNAL
• A beep sounds when one of the doors remains open for more than 3 minutes. To stop the
beep, close the door.
• An error code ("E0", "E1", "E2") indicating a temperature fault may appear on the display
(see "Troubleshooting Guide" for error codes). A beep will sound until the problem
is resolved.
• When power is restored, if the temperature in the freezer is above -10°C, the temperature
of the freezer compartment flashes on the display. Press any button to stop flashing or
wait 5 seconds for the screen to return to normal display.

Water dispenser

This refrigerator is equipped with a water dispenser that you can easily fill up so that you
always have cool water available. The water dispenser is equipped with a 5.5 litre water tank.
indicator
indicator light turns off.
37
V.1.0
using the appliance