Hilti SFE 2-A12 Notice D'utilisation Originale page 18

Masquer les pouces Voir aussi pour SFE 2-A12:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault
The power tool does
not work.
The control switch
cannot be pressed,
or is stuck.
Running speed sud-
denly drops consid-
erably.
The battery runs
down more quickly
than usual.
The battery doesn't
engage with an audi-
ble click.
The power tool or
the battery becomes
very warm.
10
Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
14
English
Possible cause
The battery is not fully
inserted.
The forward/reverse
switch is in the middle
position.
Low battery.
Very low ambient tem-
perature.
The retaining lugs on the
battery are dirty.
Electrical fault.
The tool is overloaded
(application limits ex-
ceeded).
Action to be taken
▶ Push the battery in
until it engages with
an audible click.
▶ Push
the
forward/reverse
switch to the left or
right.
▶ Change the battery
and charge the empty
battery.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Clean the retaining
lugs and engage the
battery in the working
position.
▶ Switch the power
tool off immediately,
remove the battery,
keep it under obser-
vation, allow it to cool
down and contact
Hilti Service.
▶ Select a suitable
power tool for the
application.
2236949
*2236949*

Publicité

Table des Matières
loading

Table des Matières