HoMedics ASGM-7000AATNDY Manuel D'instructions page 7

IB-ASGM7000AATNDY-0320-01.qxp_Layout 1 27/04/2020 13:15 Page 7
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to
protect the massage mechanism during shipment, which must be removed
before the first use to allow the shiatsu feature to function. Use the provided
Allen key. Then, properly dispose of the screw.
Failure to remove screw may cause permanent damage to the
appliance.
WARNING Error: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of
the massage cushion (using the allen key included). Should the condition
continue after this please contact your HoMedics service centre.
Strapping System
The massager incorporates a unique strapping system which allows you to
fasten it to almost any chair. Just slip the straps over the seat or chair and
adjust fastening straps to secure. Your massager won't slip or slide away.
NOTE: Do not use this product for more than 15 mins at a time.
NOTE: complete steps 1 and 2 before switching the appliance on at the
mains.
1. Attach the Massage seat to almost any chair using the integrated strap
located at the back of the seat. Ensure it is held firmly in place by
adjusting the strap as necessary.
2. Connect the power supply lead into a 220-240V AC mains outlet and
switch on.
3. Once seated, use the remote control to operate the appliance.
Press the q button.
Demo mode
– Press demo button
s
– Up/Down arrows will flash for shoulders
s
– Press down arrow to lower the shoulder mechanism on to your
shoulders (the nodes will partially inflate before the mechanism starts
to move, hold until the nodes reach your shoulders then release the
button – the nodes will then deflate before massage starts)
– Demo mode will then cycle all massage modes
Air Shoulder massage mode
– Use Up/Down arrows
s
– Press down arrow to lower the shoulder mechanism on to your
shoulders (the nodes will partially inflate before the mechanism starts
to move, hold until the nodes reach your shoulders then release the
button – the nodes will then deflate)
– Press the shoulder massage button
compression massage – intensity can be set using the +/- button
(Note: intensity for both shoulder and lumbar are controlled
simultaneously)
s
to activate Thai air
Gentle heat is controlled simultaneously on gel shiatsu back massage
and Thai air compression shoulder massage
4. Select lumbar air massage
/ / as required.
5. Press the q button to stop the massage.
Using essential
oils with the
aroma tab
Gently pour a few drops
of oil onto the aroma
tab, releasing the scent
in the air. The more
drops, the stronger the
scent.
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a
soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner
etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact with
sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, DO NOT wrap the power cord around the
appliance. DO NOT hang the unit by the cord.
Back flap
This massage cushion incorporates a removable back flap in suede finish
fabric to add comfort to the massage experience – this is used to soften the
massage if too intense.The flap is easily removed as secured by hook and eye
fastening. To clean back flap only simply follow the wash instructions:
.
GB
I 7
and/or shiatsu gel massage