Water Fill - MoistAir MA0601 Manuel D'utilisation Et D'entretien

Step 3. Water Fill
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area. If
controls get wet, let them dry
completely and have unit checked
by qualified service personnel before
plugging in.
After the humidifier is positioned
where it will be operating, you are
ready to fill the humidifier. The bottle
tilts out and away from the base.
Take care not to bump or damage fill
valve assembly on the bottom of the
bottle.
Invert the bottle. Press the valve
stem button into the bottle and turn
clockwise to lock in open position.
Place bottle under the faucet. Fill the
bottle, being careful not to allow any
debris to get in the valve seating.
Once the bottle is full, press the
valve stem button and turn counter
clockwise to release and close
CAUTION: Use only EPA Registered
Bacteriostat . Under no circumstances
should you use water treatment products
designed for Rotobelt or Ultrasonic
humidifiers.
Place the water bottle back into the
humidifier base. When positioned
properly, the plunger will open and
the water will flow into the base. The
base will hold the entire contents of
the water bottle. Once the bottle is
empty, remove it and repeat the
filling process. The humidifier is now
filled to capacity. For less frequent
filling let the humidifier exhaust both
the water from the bottle and the
base before filling.
.
6