Powering Built Machine; Turning Controller And Motor On - THINK GIZMOS TG632 INGENIOUS MACHINES Manuel De L'utilisateur

3. POWERING BUILT MACHINE

3.1 Turning Controller and Motor On

Once you are certain you have the channel configured correctly and the motor connected.
You are ready to power your machine.
1. Ensure the power switch on the motor is set to the "ON" position. The LED light on the
motor should flash to confirm.
2. Press the F4 key on the Remote. The LED on the motor will now stop flashing. This
confirms that the Controller and the motor are now connected.
3. Congratulations! Your Ingenious Machine is ready to go. Use the controller to command
your machine to move.
5