Using The Tool; Grain Size; Transport And Storage - J.C. SCHWARZ JTS 225 Mode D'emploi

Using the tool

Warning! Only switch the tool on when
the sanding pad is in full contact with
the workpiece and with an appropriate dust
collection system connected.
1. Switch on the dust collection system.
2. Place the tool on the drywall so that the com-
plete sanding pad 9/10
3. To switch on the tool, slide the On / Off
switch 15 to the left to position I.
4. Hold the tool fi rmly with both hands at its han-
dles 5/16 while working.
5. Adjust the speed
the speed level setting keys 14.
6. Move the tool slowly over the drywall in paral-
lel lines, circles or crosswise movements and
successive passes.
7. To switch off the tool, slide the on / off
switch 15 to the right to position 0.
8. Unplug the tool after work and before breaks.

Grain size

Depending on the operation purpose, choose the
correct grain size:
OPERATION
Removal
Preparation
Finish
106 EN
is in contact.
level 13 (level 01 to 06) with
GRAIN SIZE
40 - 60
80 - 120
180 - 240

Transport and storage

Before transport and storage:
- Make sure the tool is switched off and un-
plugged
- Remove the sanding pad 9/10
- Remove the extension tube 3
- Remove the dust hose 1
- Fold the tool
- Store all parts in the transport case as shown
below:
Store the tool and its accessories:
- together with this manual
- in its transport case
- in a dry place above freezing temperature
- out of the reach of children.