J.C. SCHWARZ JTS 225 Mode D'emploi page 105

1 DUST HOSE
Loosen the hose connector
or on the extension tube and slide in the
dust hose 1.
Warning! Never use the tool without a
dust collection system..
1 REPLACEMENT OF SANDING PAPER
To remove the sanding paper carefully
peel it off the sanding pad.
Do not use the same sanding paper for
different materials.
1 SANDING PAD REMOVAL / EXCHANGE
Pull the sanding pad
to the left.
Remove the sanding pad
tool.
3
Put the sanding base plate
sanding pad 9/10. In doing so align its
grooves with the guide rails
sanding pad.
1 SETTING THE ORIENTATION OF THE
TRIANGULAR SANDING PAD
Push the rotation lock
counter-clockwise towards . Rotate the
triangular sanding pad
position.
2
2 on the tool
2
2
latch 8 and slide it
9/10 from the
4
11 onto the
7 on the
gaged.
2
6 and turn it
9 to the desired
Tighten the hose connector 2
or on the extension tube and connect the
hose to a suitable vacuum cleaner.
To remove the dust hose 1
connector 2.
Align the holes in the sanding paper with
the ones in the sanding pad
press the sanding paper into place.
Turn the shaft of the sanding base plate
with the alignment key if necessary, so
that its orientation matches its counter-
part at the sanding pad that you wish to
insert.
Slide the sanding pad latch 8
until it engages. If necessary, repeat step
2 and 3, until the latch engages.
Warning! Do not use the tool, as long
as the sanding pad latch is not en-
Push the rotation lock 6 again and turn it
clockwise towards , until it jumps out.
Warning! Do not use the tool, as long
as the rotation lock is not engaged.
on the tool
loosen the hose
9/10 and
to the right,
EN 105