JVC KD-R647 Manuel D'instructions page 15

Wiring connection
KD-R647 KD-R641 / KD-R547 / KD-R541 /
KD-R449
Front output
Rear/subwoofer output
To the steering wheel remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the supplied
power cord D as illustrated.
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord
(not supplied)
Rear/subwoofer output
(Not available for KD-R447 / KD-R443 / KD-R442 / KD-R441)
Rear ground terminal
Aerial terminal
Light blue/yellow
STEERING
KD-R641 only
WHEEL
REMOTE
If your car has an ISO terminal
( or )
If your car does NOT have an ISO terminal
* Custom wiring harness (separately purchased)
IMPORTANT: A custom wiring harness (separately
purchased) which is suitable for your car is
recommended for connection.
Remote wire
To Blue/white
(not supplied)
wire of the wiring
harness D
JVC Amplifier
Fuse (10 A)
ISO connector
Purple ª / Purple/black ·:
B1/B2
Rear speaker (right)
Gray ª / Gray/black ·:
B3/B4
Front speaker (right)
White ª / White/black ·:
B5/B6
Front speaker (left)
Green ª / Green/black ·:
B7/B8
Rear speaker (left)
To mobile phone system
A2
(Brown)
A4 Yellow: Battery
A5 Blue/white: Remote wire
Orange/white: Car light control
A6
switch
A7 Red: Ignition (ACC)
Black: Earth (ground)
A8
connection
13
Part list for installation
A Faceplate
( ×1 )
B Mounting sleeve
( ×1 )
C Trim plate
( ×1 )
D Wiring harness
( ×1 )
E Extraction key
( ×2 )
ENGLISH