EUROM Oasis 303 Wifi Livret D'instructions page 37

ON/OFF button
Press the ON/OFF button to turn the apparatus on or off. When the apparatus is
turned on, the display will show the current humidity percentage, the ventilator
speed will be set to 'medium', and the apparatus will humidify continuously (this is
without setting the target humidity percentage).
Illumination / Sleep Mode button
Using this button, the light intensity of the control panel can be adjusted and the
apparatus can be turned on of off in sleep mode.
By consecutively pressing this button you can set the following:
Position 1 - Dimmed light
Position 2 - Normal light
Position 3 - Bright light
Position 4 - Turns on sleep mode. The corresponding symbol lights up.
In sleep mode, the ventilator speed is automatically set to 1 (low) and
the illumination of the control panel is switched off.
You cannot use the humidity percentage setting button in sleep mode.
The other buttons can be used. If you press the AUTO button, sleep
mode will be switched off.
Position 5 - Turns off sleep mode. The corresponding symbol will be off.
The device returns to the previous humidification level and timer
setting.
AUTO button
If you press the AUTO button, the apparatus will keep the humidity on the ideal
level of 50%. (This means that the apparatus will not operate when the humidity in
the room is above 50%!)
Humidity Percentage Setting button
Use this button to set the desired humidity percentage. The display shows the set
humidity percentage for a few seconds and subsequently the currently measured
humidity percentage. The humidity can be set to between 40% and 75%.
As soon as the desired humidity level is reached the apparatus will stop operating.
When the humidity drops below the set value, the apparatus will resume its
operation. If you select 'CO' (continuously), the apparatus will operate continuously
i.e., without stopping.
Timer button
Press the Timer button to set the desired operating time. Press this button a few
times to set the number of hours (1 – 12 hours). The display shows the remaining
time.
Ventilator Speed button
Use this button to set the desired ventilator speed:
1 – Low, 2 – Medium, 3 – High, 4 – Turbo
37