Publicité
Les langues disponibles
Les langues disponibles
Audi A3
1996 - 2003
Ref. 0638
Fitting instructions
1)
Disassemble the bumper in the rear of the vehicle.
Permanently remove the reinforcement beam lagging behind, this will be replaced by the tow bar.
2)
Assemble the tow bar by sliding the supporting arms in the chassis so that the points (A) match the
provided holes in the side of the chassis. These holes have to be cleared because they are sealed.
Insert the bolts and the washers and tighten firmly.
3)
Replace the bumper.
4)
Assemble (*) and tighten firmly.
Composition
1 tow bar reference 0638
1 ball T43M002
4 bolts M12x40
4 security washers M12
1 security shackle (800053)
4 bolts M10x35
4 security washers M10
4 washers 40x35x12x4
1 Socket plate P03
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*)
(*)
(*)
(A)
(A)
(A)
(*)
All bolts and nuts : quality 8.8
Publicité
