SmartLab walk B Mode D'emploi page 31

Setting time:
After that, your device enters the time setting mode. Press the "M/" button in order
to switch between the two display modes 12h and 24h (24h mode is preset).
By pushing „Disp/ Set" button you can set the time. First you set the hours by
pushing the "M/" button. Confirm by pushing „Disp/ Set". Afterwards, you can set
the minutes by repeating the steps mentioned. Finally confirm again with the „Disp/
Set" button.
Note: Setting your weight and step length is essential for the display of walked
distances and burned calories. You need to enter correct values for both parameters.
Otherwise it is impossible for smartLAB
walk B to display correctly your walked
®
distance and calory consumption.
31