SmartLab walk B Mode D'emploi page 30

With the "M/" button you can adjust your weight. You can only increase the
value. After reaching the maximum level of 200 kg, smartLAB
with 30 kg again.
By keeping the "M/" button pushed, the weight value increases faster. After
having set your personal weight, press „Disp/ Set" to confirm.
Setting step length:
After you entered your body weight, the step length symbol flashes. Now you can
enter your step length by pressing the "M/" button. The step length can vary
between 30 and 120 cm. After having set your correct step length, confirm with
„Disp/ Set".
Setting signal tone:
After you entered your step length, you can set the device signal tone ( ). By
pushing the "M/" button, you can choose if the signal beep is activated ("ON") or
not ("OFF"). Please confirm again with the „Disp/ Set" button.
30
walk B will start
®