‼ NOTE
•
Console will show "- - - -" code when safety
key is not in (correct) position.
Circuit breaker (Fig� E-2 #B)
The equipment is equipped with a circuit breaker
that interrupts the circuit when the electricity load
is above the maximum capacity. When this occurs,
the circuit breaker must be pressed.
⚠ WARNING
•
Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
‼ NOTE
•
Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill is
tripping the circuit breaker (even though it is
the proper current rating and the treadmill
is the only appliance on the circuit) but
the circuit breaker on the treadmill itself
does not trip, you will need to replace the
breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a
manufacture have no ability to control.
Unfolding and folding the
equipment (fig� F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.
Adjust incline setting (Manual)
- Fold up your treadmill. (Up)
- Take out adjuster pad safety pin.
- Adjust the adjuster pad in desired position.
- Secure the adjuster pad position with the safety
pin.
- Unfold your treadmill. (Down)
‼ NOTE
•
Make sure both adjuster-pads are in same
position to avoid your treadmill to become
unstable.
Warranty
Tunturi purchaser's warranty
Warranty terms
The consumer is entitled to the applicable legal
rights stated in the national legislation concerning
the commerce of consumer goods. This warranty
does not restrict these rights. The Purchaser's
Warranty is only valid if the item is used in an
environment approved by Tunturi New Fitness BV,
and is maintained as instructed for that particular
equipment. The product-specific approved
environment and maintenance instructions are
stated in the "user manual" of the product. The
"user manual" can be downloaded from our
website. http://manuals.tunturi.com
Declaration of the
manufacturer
Tunturi New Fitness BV declares that the product
is in conformity with the following standards and
directives: EN957 (HC), 2014/ 30/ EU.
The product therefore carries the CE label.
04-2020
Tunturi New Fitness BV
Purmerweg 1
1311 XE Almere
The Netherlands
Disclaimer
© 2020 Tunturi New Fitness BV
All rights reserved.
- The product and the manual are subject to
change.
- Specifications can be changed without further
notice.
- Check our website for the latest user manual
version.
English
15