Raise3D Pro3 Serie Manuel De L'utilisateur page 40

Imprimante 3D
J.
Removing Prints
4
5
6
37
Série Pro3 / Manuel de l'Utilisateur
Bend the build plate repeatedly until
prints are detached from the build
plate.
NOTE: Do not directly touch the edge of
the build plate to avoid injury. Do not
over-bend the plate to avoid damaging
the plate or causing the plate to bounce
off from hands. It is better to bend the
plate along the prints' longer span.
If the prints are not entirely loose or are
hard to remove after bending the plate,
use the spatula from the attached
accessories to remove the prints.
Use one hand to hold the plate, making
sure to keep it away from the spatula
blade. Use your other hand to scrape
off the prints with the spatula. We
recommend gliding the spatula blade
over the plate and aim the gap between
the prints and the plate. If the prints are
printed with the Raft, it is better to
scrape the prints along the infill
direction of the Raft.