Raise3D Pro3 Serie Manuel De L'utilisateur page 39

J.
Removing Prints
1
> 10 cm
2
3
Imprimante 3D Série Pro3
Make sure the printer is idle, and that
there is at least a 10 cm gap between
the prints' top and the nozzle.
Wait for the build plate and nozzles to
cool down to room temperature before
removing any prints. If you wish to
remove prints before they have
sufficiently cooled down, wear the
heat-resistant gloves from the attached
accessories.
Lift the build plate handle a little bit to
detach the build plate from the Z
platform.
/ Manuel de l'Utilisateur
36