Huawei B618 LTE CPE Guide Rapide page 11

3. Accessing the Internet through an Ethernet port
You can connect the router to a wall-mounted Ethernet port using an Ethernet
cable to connect to the Internet when you have used up your data allowance.
Configure the relevant settings on the web-based management page before
connecting to the Internet through an Ethernet port. More information can be
found in the help section of the web-based management page.
4. Restoring to Factory Settings
If you forget some configuration parameters, you can restore the LTE CPE to its
factory settings and then configure the LTE CPE again.
Use a sharply pointed object to press and hold the RESET button until the Power
indicator turns off. The LTE CPE is then restored to its factory settings.
Note:
After you carry out this operation, the LTE CPE's personal configuration
parameters will all be deleted. All configurations on the web management page
will be restored to the factory settings.
9