Gys Tech Software - GYS Gysmeter Mode D'emploi

SHORT DISTANCE MEASUREMENTS
The measuring tool features an adaptor for "short distance measurements".
Screw the holder in the measuring arm and choose the appropriate socket/tip.
The measures can now be taken from 400 to 2150 mm.
NOTE! Change the measuring range to 400-2150mm by pressing the ON/O key for
2 seconds. Assemble a 100mm height rod in the lower edge of the measuring tool.

GYS TECH SOFTWARE

The GYSTECH software can be downloaded by clicking at the following address :
http://www.gys-welding.com/distFiles/GYSMETER_install.exe
As the software starts up, click on the flag of the chosen language, then on START.
The below window shows up:
1- Select 2 points diagonally to make the line 1 show up. The software will automatically
generate the other lines.
2- Fill in the appropriate fields with the measures taken.
3- Click on « verify »
4- Fill in the information of the measured vehicle
5- Click on « PDF Report » to generate a report, which can be printed, saved, and sent by e-
mail.
17