Introduction; Maintenance - GYS Gysmeter Mode D'emploi

INTRODUCTION

GYSMETER is an electronic measurement device designed for measuring and checking dimensions of vehicle
unibody and frame.
The tool consists of the following components:
•
Gysmeter
•
2 magnetic chassis attachments
•
2 datum rods
•
3 height measuring rods
•
Measuring sockets and tips
•
1 panel
•
Software for saving and printing the measure results, available at www.gys.fr.
The equipment described above allows measuring length in 2 dimensions. You can also compare the
symmetry in height between left and right sides, in a very effective way.
This instruction manual contains a description of the equipment and directions for its use, handling and

maintenance.

IMPORTANT!
Read carefully the instructions for an optimal use of the GYSMETER equipment.
The equipment is intended for use in the auto body shop environment and in accordance with all recognized
official safety procedures.
Photos and drawings used throughout these instructions depict the fundamental features and design of the
product at the time of publishing and do not reflect potential future design changes.
WARNING!
Do not store or keep GYSMETER near computers, credit cards or other magnetic sensible devices, as
the magnet in the chassis attachment may damage
MAINTENANCE
General information
The GYSMETER measuring tool is composed of a high precision electronic measuring arm, which necessitates a
specific maintenance in order to maintain its performances on the long term.
Please follow all instructions and safety procedures very carefully to maintain equipment reliability and to benefit
from all of its great features.
Maintenance
Clean the product after every use.
The electronic measuring arm requires a specific cleaning, and in particular the mobile parts.
Use a clean dry cloth without any liquid or detergent.
Return all parts to the wall stand after each and every use. Regularly check the measuring arm and all the
accessories.
Recycling
When scrapping the product, it is important to sort all parts depending on their composition according to local
disposal regulations.
Battery replacement
The digital circuit of the TECH-D measuring arm is powered by 2 x AA 1.5 Volt
Batteries should be replaced when the digital display begins to flash. It is recommended that
both batteries should be replaced at the same time. The batteries should be disposed of
in accordance with local disposal regulations.
Release the battery cover by hand or with a small flat blade screwdriver.
NB: the batteries should be installed according to the diagram molded on the inside of the battery compartment
to ensure correct terminal polarity.
Do not use batteries with power ratings other than 1.5 Volt as this can cause the equipment to malfunction or
damage the digital circuit.
these.
batteries.