Accessories; Technical Specifications - GYS Gysmeter Mode D'emploi

ACCESSORIES

TECHNICAL SPECIFICATIONS

• The precision of the level will depend upon the extension length of the measuring arm.
• Refer to the table below for the height tolerances :
• Measuring range:
- Normal measure: from 900 to 2650mm
- Short measure: from 400 to 2150mm
• Datum rods' difference in height = 100 mm
14
Height level rods
The measuring tool includes 2 height level rods of two different lengths.
Magnetic holder
This magnetic holder is developed to suit most vehicle models on the market.
Use it when a round or oval hole <Ø35 mm is specified as the zero point on the
vehicle dimension data sheet.
Height measuring rods
3 height rods are included.
Rod height is determined by the data sheet and should allow for the specified
reading to be observed when the rod has been locked in place on the measuring
arm.
Insert the rod into the measuring head at the front end of the measuring arm.
Position the flat side of the rod towards the "release" mark, set it at the desired
height and secure by twisting it to the "lock" position
Level
On the measuring head is a level to compare height differences.
Measuring sockets and tips
GYSMETER includes:
- 5 measuring tips (2 x Ø25, 2 x Ø35 mm and 1 x Ø60 mm)
- 16 sockets sized from 10-26 mm
- 9 M201 adaptors 6-18
- 1 90° holder
Sockets and tips snap into the top of the height measuring rods.
Extension in mm Height tolerance in mm
900 approx. 0,5
1800 approx. 1,0
2650 approx. 1,5