Publicité
Laser Safety
+ AirAssure™ Indoor Air Quality monitors are Class 1 laser-based instruments.
+ During normal operation, you will not be exposed to laser radiation.
+ You will not be exposed to the laser radiation when the AirAssure™ IAQ monitor is disassembled.
+ The PM sensor has a laser inside it. DO NOT open the PM sensor inside AirAssure™ IAQ monitor
when the AirAssure™ IAQ monitor is powered.
Take these precautions:
+ DO NOT remove any parts from the AirAssure™ Indoor Air Quality monitor unless you are
specifically told to do so in the manual.
The use of controls, adjustments, or procedures other
than those specified in the manual may result in
exposure to hazardous optical radiation.
When operated according to the manufacturer's instruction, this device is a Class 1 laser product as defined by U.S.
Department of Health and Human Services standards under the Radiation Control for Health and Safety Act of
1968. A certification and identification label like the one shown below is affixed to each instrument.
Environmental/Installation Requirements
Maximum Altitude
Pollution Degree
Installation/Overvoltage Category
Labels
Advisory labels and identification labels are attached
to the instrument.
Serial Number Label (Back)
Laser Radiation Label
(internal, on the PM sensor)
Safety Details
European symbol for
non-disposable item.
Item must be recycled.
WARNING
2000 meters (6,560 feet)
2
II
FCC ID: 2AC7Z-ESPWROVERE
Contains IC ID: 2AC7Z-
ESPWROVERE
WARNING
If the AirAssure™ IAQ monitor is used in a manner not
specified by the manufacturer, the protection provided
by the equipment may be impaired
Reusing and Recycling
As part of TSI® Incorporated's effort to have a
minimal negative impact on the communities in
which its products are manufactured and used:
+ If instrument becomes obsolete, return
to TSI® Incorporated for disassembly
and recycling
11
Publicité
