Duronic HV180 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Keep the appliance and cable away from sources of heat, sharp objects or
anything that might cause damage.
To avoid overheating, do not cover the heater. To prevent a possible fire
hazard, do not block the air intakes or the outlet in any way.
Ensure the appliance is always switched off before connecting it to the mains
power supply.
This appliance is not intended to be operated using an external timer or
separate remote-control system.
Do not plug the heater into an extension lead or multi-plug power adapter
as the heater is too powerful for it. Using an extension lead or adapter with
this heater is a fire hazard and may cause damage to the heater or the user.
Always plug a heater directly into a mains socket.
Switch off the power supply and unplug the appliance whenever it is not in
use, before cleaning it or carrying out any maintenance.
Ensure the heater is positioned at a minimum distance of 1 metre from any
wall or objects.
This heater must not be located immediately below a plug socket.
To disconnect the appliance, switch it off, and then remove the plug from the
socket.
Do not pull the cable to unplug it.
Do not operate the heater in areas where petrol, paint or other flammable
liquids are used or stored.
Do not touch the hot surfaces.
Do not leave this appliance unattended when it is in use.
The most common cause of overheating is deposits of dust or fluff in the
appliance. Ensure these deposits are removed regularly by disconnecting the
appliance and then vacuum cleaning the air vents and grills.
Place the cable in such a way that it is not in any high traffic area to avoid it
being tripped over or stood on.
9

Publicité

Table des Matières
loading

Table des Matières