Publicité
Les langues disponibles
Les langues disponibles
eXtend load aRms.
on the inner hubs,
pull and turn the
red triggers.
unlIsteD vehIcles:
load aRms
load heaviest biKe fiRst
attach one rubber strap to each
cradle and stabilizer.
To slide cradles along the carrier
arms, close cradle and stabilizer. Close
cradles while loading bikes.
secure the front
wheel on the bike
closest to the car.
Use extra strap to
secure the wheel.
1033359E - 7/24
rotate load
arms to
just above
horizontal.
always load first bike with
chain away from vehicle.
always use the cradles
closest to the vehicle.
\
stabilizer
tighten uppeR and side stRaps
again afteR biKes aRe loaded.
cautIons:
• adjust load arms to just above horizontal.
• make sure bikes have sufficient clearance
from the ground.
arrange bike frame in the cradles for greatest stability.
tightly secure straps diagonally
over bike frame and seat tube.
The straps can be routed
under the cables.
the weight of the bikes
may cause the straps to
slack or dislodge hooks.
replace reD trIggers.
• make sure that both triggers
are seated in the hub!
• move both arms up and down,
they must snap into place!
if the arms do not
snap into place,
adjust triggers and
move arms until the
arms are in place.
loaD remaInIng
bIKes.
alternate bike directions
to avoid interference.
befoRe
dRiving away
with youR
biKes:
reaD all
warnIngs on the
page after next.
Publicité
