Trevi RC 858 PJ Manuel D'utilisation page 5

RC 858 PJ
2. Set the alarm time by repeatedly pressing HR and MIN respec-
tively.
• Press and hold HR and MIN respectively for fast advance.
3. Press AL1(4) or AL2(3) again to select the alarm sound
(OFF>BUZZER>RADIO in cycle).
CHECKING ALARM TIME
Press and hold AL1(4) or AL2(3) for 2 seconds, the alarm time
will flash on the display.
To turn off the alarm, press POWER(1) and the alarm will come on
again at the set time on the following days.
To cancel the alarm, repeatedly press AL1(4) or AL2(3) until the
alarm indicator light goes out on the display.
SNOOZE FUNCTION
This function can be used to stop the alarm temporarily for about
9 minutes once the alarm is activated. When the snooze button
is pressed, the buzzer or radio alarm sounds will stop and sound
again after about 9 minutes.
SLEEP TIMER OPERATION
The sleep function is designed to automatically turn off the Radio.
SETTING SLEEP TIMER
1. Press SLEEP(8).
• "90" will illuminate on the display.
2. Repeatedly press SLEEP(8) to select
the desired sleep time from 90, 80, 70,
60, 50, 40, 30, 20 or 10 minutes.
3. The radio will be turned off after the selected time has elapsed.
To check remaining sleep time, press SLEEP(8).
To cancel sleep timer, press SLEEP(8) until
"OFF" is selected.
To turn off the radio before the sleep time
has elapsed, press POWER.
PROJECTOR
Switch on the projection clock with the PROJECTION ON/OFF(14).
Rotate: Scroll for setting the best projection clock viewing angle.
FOCUS THUMBWHEEL(15): Scroll for setting the best projection
clock image.
DIMMER CONTROL
Repeatedly press DIMMER to adjust the brightness of display
(bright or dim).
SPECIFICATION
Power Source: .......................... 230V ~ 50Hz
Clock backup: .......................... 2x 1,5V
Radio Frequency: ..................... AM 522-1620kHz:
Power Consumption: ................. < 1W
Size: ........................................153 x 60 x 98 mm
AM/FM ALARM CLOCK PROJECTION
("AAA"size,
Not included)
FM 87.5-108MHz
USERS INFORMATION pursuant to Legislative Decree
No. 49 of March 14, 2014
"Implementation of Directive 2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE)"
This wheeled bin symbol on the product indicates that at the end
of its life must be collected separately from other waste. The user
must, therefore, take the remote control integrates the essential
components that got to its life to the appropriate differentiated
collection centers for electronic and electro-technical waste, or
return it to the dealer when purchasing a new appliance of equivalent
type, in terms of one to one, or one to zero for equipment having
longer side of less than 25 cm. Appropriate separate collection
for the decommissioned equipment for recycling, processing and
environmentally compatible disposal helps prevent negative impact
on the environment and human health and promotes recycling of the
materials making up the product. Illegal dumping of the product by
the user entails the application of administrative sanctions stated in
Legislative Decree n. Legislative Decree No. 49 of March 14, 2014.
ENGLISH
5
5