Neuton CE 5 Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Starting the Trimmer
The Battery in the NEUTON Mower powers the Trimmer, making the cutting cord spin. Make sure the Battery has a full charge
before you begin.
Starting, stopping, and restarting an electric motor repeatedly within a few seconds can generate a great deal of heat and
damage the Motor. To protect the life of your NEUTON Trimmer, always wait at least five (5) seconds after stopping before
restarting the Trimmer.
The Cutting Cord always turns when the Motor is running; there is no clutch to allow the Cord to stop rotating while the
Motor is running.
1.
Set the Mower/Auxiliary Switch to Auxiliary.
NOTE: The Cutting Blade on the Mower does not turn when the Mower/Auxiliary Switch is in the Auxiliary position.
2.
Insert the Safety Key into the Key Slot. The green Status Indicator Light should come ON.
3.
Slide the orange Start Knob to the left and then squeeze and hold the orange Control Bar. The Trimmer Motor will
now start and run for as long as you are squeezing the Control Bar.
Stopping the Trimmer
Simply release the Control Bar to Stop the Trimmer.
The Trimmer will continue to rotate for a couple of seconds after you release the Control Bar. Wait for the Motor to stop before
moving the Mower. Remember to wait at least five (5) seconds after stopping before you restart the Trimmer Motor.
When you are finished trimming or edging, remember to remove the Safety Key.
Advancing the Cord
Each time the Trimmer starts or comes to a complete stop, the Trimmer's Cutting Cord automatically advances and cuts itself
to 5-1/2" resulting in an eleven (11) inch cutting swath.
You can also manually advance the Cord.
1.
Release the orange Control Bar to stop the Trimmer Motor and remove the Safety Key.
2.
Push in the white Button on the side of the Spool Housing (Figure 9) and pull the Cord to advance it. The Cord
advances in small increments so you might have to push the Button a few times.
NOTE: Try not to advance the Cutting Cord past the Trimmer Shield. If you do pull out too much Cord, the Cutter on the Trimmer
Shield automatically trims the length of the Cord (Figure 10).
Be careful, the excess Cord will fly off when you start the Trimmer and could be dangerous.
White Button
Figure 9
Safety & Operating Instructions
NEUTON Trimmer -
Cord Cutter
Housing
Figure 10
5

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ce 6

Table des Matières