Neuton CE 5 Mode D'emploi page 6

Model: CE 6
Attaching the Trimmer
1. Adjust the Mower Cutting Height Lever to position four
(4); this sets the Cutting Height to the highest level.
2. Insert the Trimmer post into the Trimmer Port in the front
of the Mower (Figure 5). The Post will snap into place
when fully inserted.
Hold the Mower so that it will not roll (Figure 5) when
TIP
inserting the Trimmer.
Adjusting the Trimmer Head
Before adjusting the Trimmer, you must first decide whether you going to Edge or Trim your lawn.
To set the Trimmer Head for edging or trimming, adjust the Mower Cutting Height Lever to position four (4); push in the
Trimmer Head Adjustment Button on top of the Trimmer and rotate the Trimmer Head to the Trim or Edge position (Figure 6 or
7). Release the Button and the Head will snap into position.
Trimmer Head
Adjustment Button
Trim Position
Figure 6
Removing the Trimmer
Push in the Trimmer Release Button (Figure 8) and pull the
Trimmer up and out of the Trimmer Port in the Mower. Once
it has started to pull out, you can release the Button.
Hold the Mower so that it will not roll when removing
TIP
the Trimmer.
4
Figure 5
Rotate Head to
Trim or Edge
Position
Trimmer Head
Adjustment Button
Edge Position
Figure 7
Figure 8
Trimmer Port
Release Button
www.neutonpower.com