Neuton CE 5 Mode D'emploi page 14

Daily Checklist and Storing for your NEUTON Trimmer
To help maintain your NEUTON Trimmer for optimum performance, we recommend you follow this checklist each time
you use your Trimmer. Also, follow the checklist for storing.
Do not insert the Safety Key until you have completed all of the daily checks and you have moved the Mower to the area
that you are going to trim/edge.
[ ] BATTERY: Make sure the Battery has a full charge.
[ ] INSPECT: Before inserting the Safety Key, inspect for any visible damage to the Trimmer. Inspect the Trimmer and
clean it to remove any debris that might be clinging to the Housing from its last use. For the best
performance, it is best to clean the Housing of any clinging debris after each use. Always follow the safety
precautions when cleaning the Housing.
Make sure the Control Bar is clean and operating smoothly. See your Mower manual.
[ ] NOISES: If you notice anything unusual, such as a vibration or odd sound, shut the Trimmer down immediately.
Remove the Safety Key and, following all safety procedures, inspect the Trimmer for any obstructions.
If you cannot find the cause of the problem or are uncertain what to do, then have the Trimmer inspected by
a qualified repair shop before using it, or visit our website at www.neutonpower.com.
[ ] TRIMMING: If you are uncertain whether the grass you want to cut is too long or thick for optimal cutting, raise the
Height and trim in multiple passes, cutting it slightly shorter each time. It is best to trim more frequently,
rather than let the grass become excessively long.
Push the Mower (before starting it) to the lawn area that you wish to trim.
NOTE: The length of time that a Battery can hold a charge while trimming/edging depends upon lawn
conditions; tall or thick grass makes the Trimmer work harder causing the Battery to discharge faster.
Cleaning and Storing
[ ] Periodically clean the Trimmer to ensure peak performance.
Supplies Needed:
•
Clean, damp cloth or sponge
•
Mild soap or detergent (if needed)
•
Soft nylon brush (if needed)
1. Remove the Safety Key and remove the Trimmer from the Mower.
2. Using a damp cloth or sponge with a mild soap or detergent, clean the Trimmer. Never use water, gasoline, solvents,
or other petroleum-based or solvent-based products when cleaning – remember that this is an electric Trimmer.
3. Use a soft nylon brush or non-metallic scrubbing pad to remove any clippings that have accumulated on the
Trimmer and underside of the Trimmer Shield. Do not use a wire brush; it will scratch and harm the surface of your
Trimmer.
4. Remove any grass or weeds that might have wound around the Spool.
5. Store the Trimmer indoors in a dry place and out of the reach of children.
Copyrights and Trademarks
©2009 Neuton Inc.
NEUTON and NEUTON logo are trademarks of Neuton Inc.
All rights reserved.
Documentation
Produced in Taiwan R.O.C. exclusively for Neuton Inc.
Neuton Inc.
7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
www.neutonpower.com ©2009 Neuton Inc. 256351