Clevo P870KM1 Guide Utilisateur Concis page 21

Thunderbolt Ports for Display
The display configuration for the Thunderbolt ports and Mini DisplayPorts can be
set up in the BIOS (Advanced menu > Advanced Chipset Control > DDI Control).
Restart your notebook computer and press F2 to enter the BIOS.
The table below outlines which ports will be enabled/disabled when the Thunder-
bolt ports are set for display only.
Setting
9
Thunderbolt 3 Port #1
Thunderbolt 3 Port #2
10
Mini DisplayPort #1 11
Mini DisplayPort #2 12
Table 4 - DDI Control (Advanced Menu > Advanced Chipset Control)
DDI to mDP
1 DDI to TBT
(Default Setting)
Disabled Enabled
Disabled Disabled
Enabled Disabled
Enabled Enabled
9
10 11 12
Thunderbolt Devices
When plugging a device into a
Thunderbolt port alllow 30 sec-
onds for the system to scan and
recognize the connected device.
2 DDI to TBT
Ejecting Thunderbolt Devices
In order to prevent system prob-
Enabled
lems make sure you do not sim-
ply pull the cable out from the
Enabled
Thunderbolt port. The hardware
must be ejected safely:
Disabled
1. Go to the notification area of
the taskbar and click on the
Disabled
Safely Remove Hardware
and Eject Media icon.
2. Click on Eject "Thunderbolt
Device Name".
3. When you see the "Safe to
Remove Hardware" mes-
sage you can remove the ca-
ble.

15