CAME MS-N5016-UH Manuel De Configuration Et D'utilisation page 53

Checking connection status
After adding IP channels, press the [Refresh] button; the connection status [state] will be displayed
as [connected]. If not, it is necessary to check the connection to the network and whether the user
name and password are correct.
Editing camera settings
To access the information about channel, IP address, password, etc, again...
Select the channel and press or double-click on the channel you want.
Edit the video camera's settings as you want and confirm your choices by pressing "Apply".
Note: by default, the user name and password are the ones pre-set, the port is 80 and the trans-
port protocol is UDP.