ALPHA-TOOLS A-FS 180/2 Mode D'emploi page 7

Anleitung A-FS 180-2_SPK7:Anleitung FSG 518-1 SPK 1
1. Layout (Fig. 1-6)
1. Miter stop
2. Parallel stop
3. Wheel guard
4. Cutting table
5. Water trough
6. Housing
7. Knurled screw for setting the angle
8. Scale for miter cut
9. Knurled screw
10. Thumb screw
11. Holder for splitter
12. On/Off switch
13. Switch housing
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
20. Fastening screws for splitter holder
2. Technical data
Motor rating 600 W S2 20 min
Motor speed
AC motor 230 V ~ 50 Hz
Insulation class
Protection type
Protection class
Cutting height 90°
Cutting height 45°
Cutting table
Dimensions 330 mm x 360 mm
Diamond cutting wheel ø 180 x ø 25.4 mm
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; 11/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the userʼs hearing
(wear ear muffs!).
Sound pressure level LPA 66.3 dB(A)
Sound power level LWA 79.3 dB(A)
3. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
4. Intended use
The tile cutting machine is designed to perform
cutting jobs on small and medium tiles (floor and wall
tiles made of ceramic and similar material) which suit
the machineʼs size. It is intended in particular for use
by DIY enthusiasts and craftsmen. The cutting of
wood and metal is prohibited. The machine is to be
used solely for its intended purpose. Any use
other than its intended use is a case of mis-use. The
user/operator and not the manufacturer shall be
liable for any damage or injury resulting from cases
of mis-use. Only those cutting wheels suitable for the
machine are to be used. The use of saw blades is
prohibited. For the machine to be used as intended it
is also imperative to observe the safety instructions,
the assembly instructions and the operating
instructions set out in this manual. All persons
entrusted with operating and servicing the machine
3000 rpm
must be acquainted with the manual and must be
informed about the machineʼs potential hazards. It is
also imperative to pay exact attention to the accident
Class B
prevention regulations in force in your country and to
observe the general rules of occupational medicine
IP 54
and safety. The manufacturer can accept no liability
I
whatsoever for damages resulting from any
modifications to the machine. Even when the
35 mm
machine is used as intended, certain residual risk
12 mm
factors cannot be ruled out completely. The following
hazards may arise in connection with the machineʼs
design and construction:
Touching of the diamond cutting wheel in the
uncovered zone.
Reaching into the area of the diamond cutting
wheel when it is running.
Catapulting of a faulty diamond tip off the cutting
wheel.
Kicking of workpieces and workpiece parts
during incorrect operation.
Damage to hearing if ear muffs are not worn.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
Idle
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
29.11.2006 9:04 Uhr Seite 7
GB
7