Publicité
Les langues disponibles
Les langues disponibles
EN
What Is
Included
AC Power
Power Linking
AC Plug
Replacing the
Fuse
DMX Linking
DMX Connection
Master Control
Master/Slave
Connection
·
OVATION™ F-95WW
·
powerCON® input cord
·
Gel frame
This product has an auto-ranging power supply that can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 15 OVATION™ F-95WW products at 120 VAC or
28 at 230 VAC. Never exceed this number. Power linking cords can
be purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder
cap from the housing.
3.
Remove blown fuse and replace with a good fuse of the same
type and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The OVATION™ F-95WW will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The OVATION™ F-95WW uses a regular DMX data connection for
its DMX personalities: UNO, DOS, and STD.P. See the User Manual
to connect and configure for DMX operation.
NOTE: For optimum control of the 16-bit dimming channels in the TR16
personality, be sure that both dimming curves in SET > DIMX and SET
> CURV are set to OFF.
The OVATION™ F-95WW allows control of other OVATION™
F-95WW products using a regular DMX data connection. See the
User Manual to configure for Master Control operation.
The OVATION™ F-95WW uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure
for Master/Slave operation.
OVATION™ F-95WW QRG
·
·
·
·
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
3
Gel frame holder
Safety cable
Warranty card
Quick Reference Guide
Screw Color
Brown
Yellow/Brass
Blue
Silver
Green
Publicité
