Publicité
Les langues disponibles
Les langues disponibles
Yorkville Synergy Convenience Receptacle Installation (Cascade Installation)
RATED CURRENT
MAINS VOLTAGE
120V 60 Hz
(NORTH AMERICA)
230V 50 Hz
(EUROPE)
The LINE CURRENT LIMIT SWITCH allows the user to limit the maximum continuous current consumption to reduced
a
values as shown.
Tech Support: If you have any questions concerning your SYNERGY equipment don't hesitate to contact
ELECTRICAL SAFETY
It is always important to connect all sound reinforcement equipment to ac mains supply circuits that have proper electrical
safety grounds. Never break off the Earth Ground pin from a 3-prong plug. This pin provides personal protection from
electrical shock and protection of the equipment from lightning strikes and electrostatic buildup. It is also required for EMC
shielding. Replace the plug if the Earth Ground pin is missing.
1. Always connect the equipment to a circuit with a suitable electrical ground.
2. Do not overload the power cords and convenience outlets.
3. Always inspect the cords and plugs before use. Do not use outlets or cords that have exposed conductors, are worn or
damaged. Replace electrical cords that have worn or damaged insulation and remember to pull the plug not the cord to
prevent damage to the cord. Only replace with the equivalent heavy-duty cord supplied by the manufacturer.
4. The AC supply cord should be routed so that it is unlikely that it will be damaged. Protect the power cord from being
walked on or pinched. If the AC supply cord is damaged DO NOT OPERATE THE UNIT. To completely disconnect this
apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle. The mains plug of the
power supply cord shall remain readily accessible. Unplug the apparatus during lightning storms or when unused for
long periods of time. Route cords away from traffic to avoid tripping hazards and unnecessary wear on the power cord.
5. Never Break Off the Third Prong on a Plug. Replace broken 3-prong plugs and make sure the third prong is properly grounded.
6. Keep line cords away from heat, water and oil. They can damage the insulation and create a shock hazard.
7. Do not tie cords in tight knots. Knots can cause short circuits and shocks. Loop the cords or use a twist lock plug.
Table 1 - SYNERGY RATED CURRENT
MODEL
SA102
SA153
SA115S
SA221S
SA315S
SA102
SA153
SA221SCE
SYNERGY-Convenience-Receptacle-(Cascade-Installation)-en-00-2v5.docx • June 23, 2022
LINE CURRENT
RATED
LIMIT SWITCH
CURRENT
(Arms)
MAX
1.0
2.5
3.0
11.0
11.0
10.2
10.2
0.5
1.5
6.3
6.3
a
(Arms)
80%
60%
8.0
6.0
10.2
8.1
4.0
3.0
synergy@yorkville.com
Publicité
