ETI ST-2-9-840-SV-N Guide D'utilisation Et D'entretien page 10

suspension Mounting (continued)
4
Connecting the power cord
nOTe: Make sure the distance between the electrical outlet and the end of the light fixture is less than 5 ft. when using the plug-in
installation method.
□ Remove the end cover plug (CC) from the strip light.
□ Plug the power cord (FF) into the end of the fixture body (B) and then plug the other end of the power cord (FF) into
an electrical outlet.
□ Secure the power cord to the ceiling using cord clips or cable raceway (not included).
□ Turn the power on to activate the light fixture.
CC
FF
nOTe: When suspension mounting using the plug-in installation method, make sure the light fixture is located directly below the electrical
outlet and that the distance between the electrical outlet and the end of the light fixture is less than 5 ft.
B
10
A