ETI ST-2-9-840-SV-N Guide D'utilisation Et D'entretien page 7

surface Mounting (continued)
5
Attaching the electrical box plate
□ Feed the electrical wires from the electrical box through the
center of the electrical box plate (GG - not included).
□ Secure the electrical box plate (GG - not included) to the electrical
box with the mounting screws (HH - not included).
6
Mounting the light fixture
□ Feed the electrical wires from the electrical box through the open knock out hole in the fixture body (B).
□ Align the two mounting keyholes on the fixture body (B) with the two mounting screws (AA) in the ceiling.
□ Once the screw heads are through the large ends of the keyholes, slide the fixture body (B) to the left until the heads of the
mounting screws (AA) slide into the narrow ends of the keyholes.
□ Finish tightening the mounting screws (AA) until the fixture body (B) is tightly secured to the mounting surface.
AA
AA
7
Please contact 1-855-384-7754 for further assistance.
GG
HH
B
www.ETiSSL.com