Worx WG509 Mode D'emploi page 9

Vacuum operating mode
uSiNg tHE BlowER (See Fig. g)
The blower is intended for residential use
only. Use the blower outdoors to move or
vacuum yard debris as needed.
CAutioN!
the blower can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
Do not blow hard objects such as
•
nails, bolts, or rocks.
Do not operate the blower near
•
children, bystanders or pets.
use extra care when cleaning debris
•
from stairs or other tight areas.
wear safety goggles or other suitable
•
eye protection, long pants, and
shoes.
VARiABlE SPEED SwitCH (See Fig. H)
The speed of the blower can be altered by
rotating the Variable Speed Switch (12). Rotate
upward to decrease speed and downward to
increase speed. Position 1 is the lowest and
Position 6 is the highest speed.
uSiNg tHE VACuuM (See Fig. i)
CAutioN!
the vacuum can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
• Do not operate the vacuum without
the bag installed or with the bag
zipper open.
• Do not vacuum sharp, pointed, or
hard objects that could be thrown
through the fabric of the bag, such as
wires, staples, nails, or rocks.
iMPoRtANt: always keep the vacuum tube
1" above debris. Do not force the vacuum tube
into a pile of debris or hold the tube upright
while force feeding debris into the tube.
either action may clog and damage the Impeller
and blade located inside the blower. If the
vacuum starts to vibrate or make abnormal
noise, stop it, unplug the cord, and check for the
cause.
12 AMP All-in-one blower/vac/mulcher EN
EMPtyiNg tHE DEBRiS CollECtioN
BAg
Turn off and unplug the vacuum from the
power source. empty the bag as shown in Fig
J-K.
Do not store debris inside the bag. To clean
the bag, turn it inside out and shake out any
excess debris. Once a year, hand wash the bag
in soapy water and allow it to air dry.
wARNiNg: Normal usage of the
Debris Collection bag causes it to
wear and deteriorate over time. A worn
or deteriorated bag allows small objects
to be thrown through the bag, possibly
injuring the operator or bystanders.
Check the bag frequently. if it is worn
or deteriorated, replace it with a new
woRx debris collection bag.
REMoViNg CloggED DEBRiS FRoM
tHE iMPEllER AND BlADE
wARNiNg: wear protective glasses
and gloves.
1. Turn off and wait for all moving parts to
stop.
2. Unplug the tool.
3. Press the release button and separate
the blower/Vacuum tube from the motor
housing.(See Fig. L)
4. Now you can remove the debris from the
Impeller as shown in Fig M. (Use an item
that is long and sturdy. be sure to be gentle
to not damage any of the internal items).
5. Check the Impeller and/or blade for any
signs of damage. If it is damaged do not
use and contact your authorized WORX
Dealer.
6. Reassemble the blower/Vacuum Tube by
referring to the assembly section of this
manual.
sTorAGE
Store the blower/vacuum and extension cord
indoors, in a cool dry location, out of reach of
children and animals.
9