Place The Earpiece On Your Ear; Turn The Earpiece On; Adjusting The Volume - Audiovox Acoustic Research Guide De L'utilisateur

Place the earpiece on your ear

1.
Put the earpiece behind your ear.
Note: If you're using the wide tube, rotate the
end of the tube so that it points to your ear.
2.
Insert the dome in your ear gently.
Then gently wiggle the dome
into the ear canal so that it is
comfortably in place.
Note: If you're using the wide tube, make sure
it's firmly in position. You may experience
feedback if the fit is too loose. Since the wide
tube has no stabilizing tail, you can skip step 3.
3.
Fold the tail into the bowl of your
ear. The tail will help stabilize the
earpiece on your ear and keep the
dome and tube in place.
If you find that the tail is too long
to fit comfortably in the bowl of
your ear as shown, you can use a
pair of scissors to trim it to a size
that works for you.
Is the dome uncomfortable?
If the medium-sized dome doesn't seem to fit right, you might need to
use the larger dome included in this package. See the Changing the
dome section later in this manual for instructions.

Turn the earpiece on

The on/off switch for the
Acoustic Research earpiece
is located on the top of the
earpiece body, just above your
ear when you have the earpiece
on. The switch is raised and
toward the bottom/back part of
the earpiece body. Flip it down to
turn the earpiece on.
Important: When you turn the earpiece on, there is a 2-3 second delay
before the earpiece starts working. This is normal.
8
All manuals and user guides at all-guides.com
Earpiece

Adjusting the volume

The AR PSA earpiece has four preset levels of sound
amplification to fit four distinct user profiles or
listening environments.
1 minimum noise reduction, low-level
amplification
2 medium noise reduction, medium gain
3 maximum noise reduction, maximum gain
4 full-range equalization, for use with music
When you turn it on, the earpiece goes to setting 1
(minimum noise reduction, low-level amplification).
Can I get more volume?
The wide tube provides more volume than the thin tubes. Before installing
the wide tube, we recommend that you try a thin tube at all four volume
levels described here. If you want still more volume than the third level,
follow the instructions on pages 6-7 to install the wide tube.
To adjust the volume: Find
the volume button directly
above the on/off switch
on the earpiece body.
Completely depress it for
1 second.You will hear 2
short beeps, which means
the earpiece is now on
setting 2.
To go to level 3, press the
volume button for 1 second
again until you hear 3 short
beeps.
To go to level 4, press the volume button for 1 second
again until you hear 4 short beeps.
To go back to level 1, press the volume button again. You
should hear 1 short beep. You can also turn the earpiece
off and back on again. The earpiece will automatically go
to setting 1 when it's turned back on.
Volume
Button
9