myPool ECO 04 Manuel D'instructions page 37

Setting
To set the heating or cooling setting, the machine must be in stand-by mode (press the button
to turn the machine into stand-by or working mode).
• Press one time the
• The number of the parameter will appear on the left, and the value of this parameter on the
right.
• Choose the parameter by pressing the
o 0 = cooling setting.
o 1 = heating setting.
• Set the parameter to the desired value with
Wait for few minutes, the setting will be recorded automatically.
Turn the machine into working mode by pressing the button
Controller state table
Screen
button.
Explanation
Indicate the desired heating
temperature.
Indicate water inlet temperature.
Number nearby this symbol is
the parameter number
button.
and
Screen
Indicate ambient temperature.
- 37 -
buttons.
.
Explanation
Heating mode
Cooling mode