Utilization Limits - myPool ECO 04 Manuel D'instructions

• Parts moving with automatic start-up (fan)
• Cutting edges (evaporator)
In order to avoid accidents, prevent close access the appliance by children and
pets. Never cover the appliance whilst in operation and never put your fingers, or
other objects inside.
Never turn on the appliance with any of its panels removed.
Pressure controller
The builder heat pumps are provided with HP pressure controller set at 30 Bar.

Utilization limits

To ensure the heat pump has been correctly sized, the builder must has been
previously contacted with a selection file (available on demand) in order to validate
such selection.
• "ECO" range heat pump models are designed to operate from +5°C to +35°C (50°F
to 95°F) air temperature using a pool cover.
If the machine is used to work with an ambient temperature below 0°, particularly for
high water temperatures, it is advised to add an electrical heater (ask your seller).
Regarding product selection that has not been validated by the builder and working
outside the above ranges; the builder dissociates its responsibility regarding any lack
of performance.
Before installing the heat pump, you will have checked that the impedance of your
swimming pool electricity power supply shall not be more than 0.042 Ω.
Ask your electricity provider if necessary.
If the electricity provider can not adjust it, it could translate into a tension reduction
on the power supply for few seconds when the heat pump starts up.
Maximum water pressure : 2 bars (29 PSI).
- 30 -