GYS CONVERGYS 300 Mode D'emploi page 9

Translation of the original instructions
ADVICE FOR USE
The CONVERGYS can be used whilst the engine is on or off. For heavy use, or use over a long period of time, you should
start the engine to prevent discharge of the vehicle battery.
Do not start the car while the CONVERGYS is connected.
Some devices require high starting power that can exceed the power of the inverter; this can engage the overload pro-
tection which will cause the machine to switch off. When using multiple devices, ensure they are turned on one after
another starting with the most powerful device.
COMPATIBILITY
Before use, you must check the compatibility of your device with the Convergys:
Compatible devices: (maximum 300 W) :
• Office equipment: computers, scanners, printers etc ...
• Digital products: mobile phones, video cameras, DVD players etc ...
• Small devices: Flat screen TVs, fans, vacuum cleaners, irons etc ...
Non-compatible devices:
• The products exceeding the limit of the converter power: 300 W
• Products with high energy consumption: air conditioners, microwaves, high power electric drills, refrigerators etc...
Compatible devices with the USB port (5V - 2100 mA):
• USB port of Convergys is suitable to power compatible devices; it cannot be used to exchange data.
• Do not connect a device greater than 2100 mA as this may damage the USB port.
• Follow the manufacturer's recommendations if the device requires a specific charger.
OPERATION
300 W MODEL:
1) Choose desired connection:
• Directly onto battery: powers any device up to 300 W.
• Cigarette lighter: powers any device up to 150 W.
2) Connection:
Connect the red clip to the red «+» terminal of the converter and the black clip to the black «-» terminal of the conver-
ter; screw clips in place.
Caution: reversing the polarity may damage the converter.
3) Connect the converter:
• Wire: Connect the black clamp to the negative «-» terminal of the battery and then connect the red clamp to the
positive «+» terminal of the battery
Caution: If the clamps are not connected securely there is a risk of low/no power, cable overheating, damage to the
inverter supply, or fire.
• Cigarette lighter: Connect the cigarette lighter plug into the socket.
4) Switch the inverter ON (the green LED illuminates) and connect your equipment to the converter. (230V or USB 5V)
5) After use, unplug your equipment and then switch OFF the Convergys and disconnect it from the cigarette lighter or
the battery.
CONVERGYS 300 EN
9 9