Peavey PV 6 Mode D'emploi page 8

Control Room Outputs (24)
The Control Room Outputs feature two
(TRS) balanced or Tip Sleeve (TS) unbalanced connectors. The Control Room Output Level is adjusted with the
Headphone Level Control (10).
EFX Send (25)
1 ⁄
The EFX Send features a
4
Sleeve (TRS) balanced or Tip Sleeve (TS) unbalanced connectors. The EFX mix is determined by the amount of
signal being sent to the EFX bus in each channel.
Headphone Output (26)
The Headphone Output is a
normally the Left/Right mix. When the Tape to Control Room switch is engaged‚ the tape input signal is added to
the Left/Right mix and can be monitored in the headphones.
Left/Right Outputs (27)
The Left/Right Outputs feature two
(TRS) balanced or Tip, Sleeve (TS) unbalanced connectors.
EFX Return (28)
The EFX Return inputs (Left/Mono‚ Right) feature two
Tip‚ Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The EFX Return is controlled via the
EFX/Return Level Control (19).
Power Adapter Input (29)
Use to connect the included power supply. Be sure the power supply is connected to the PV
to a power source. Use 16 VAC 1 A adapter only.
Power Switch (30)
Depressing the power switch applies power to the unit.
Tape In/Out (32 & 31)
The tape input jacks are designed to accommodate tape‚ CD or computer sound card output levels. The out level is
+4 dBu for connection to a recorder or sound card input. The tape inputs can be used as an additional stereo input
by engaging the Tape to Main Mix switch (15). The tape input can also be used to monitor the recorder/sound card
output without the risk of feedback.
1 ⁄ " TRS Z-balanced jacks. These outputs can be used with Tip‚ Ring Sleeve
4
" TRS Z-balanced jack in the master section. These outputs can be used with Tip‚ Ring
1 ⁄ " TRS (tip = left; ring = right; sleeve = ground). The signal sent to this output is
4
1 ⁄ " TRS Z-balanced jacks. These outputs can be used with Tip‚ Ring, Sleeve
4
8
1 ⁄ " TRS Z-balanced jacks. These outputs can be used with
4
® 6 before connecting