Stadler Form Oskar Mode D'emploi page 7

• Do not run the power cord over sharp edges and make sure that it does
not get trapped. Do not pull the plug from the socket with wet hands or by
holding on to the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or
a swimming pool (observe a minimum distance of 10 ft / 3 m). Place the
appliance such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
Setting up / operation
1. Place the Oskar room humidifier on a flat surface in the desired area. Use
the filling opening (11) to fill the lower part (2) with water up to the maxi-
mum mark (14), either at a water tap or with a watering can. When you
have filled the lower part at the tap, carefully fit the upper part (1) to the
lower part (2). Plug the mains cable (3) into a electric socket.
2. Start the appliance by pressing the on/off switch (5). The blue LED should
then light up. If a red pilot lamp (10 and 14) lights up however, this indi-
cates either lack of water in the appliance or failure to seat the upper part
correctly on the lower part.
3. By pressing the speed level selector button (6) you can change the humid-
ity output (a blue lamp for normal evaporation, two blue lamps for high
evaporation).
4. You can use the hygrostat to set the desired air humidity. To do this, press
on the hygrostat button (7). You can choose between the following lev-
els: 40 % relative air humidity (1 blue lamp), 45 % (2 blue lamps), 50 %
(3 blue lamps), 55 % (4 blue lamps), constant operation (5 blue lamps). If
the lamps are flashing, this indicates that the desired air humidity has al-
ready been reached. Please note that the hygrostat needs about 3 second
to measure the current humidity in the room. The hygrostat switches on
automatically once the relative air humidity in the room sinks below the
preset value. We recommend that you set your room humidity to 45 %
(comfort range).
5. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (8). You can choose
between three different modes:
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)