Homelite HL80833 Additif Au Manuel D'utilisation page 16

RiNSiNg wiTh ThE PRESSURE wAShER
 Turn off the pressure washer and shut off the water
supply. Point nozzle in a safe direction and pull trigger to
release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the top of the machine.
 Select the right nozzle for the job:
• Use medium pressure nozzle (green) for items such as
a car or boat.
• Use higher pressure nozzle for jobs such as stripping
paint and degreasing the driveway. When using these
nozzles, test a small area first to avoid surface damage.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
USiNg ThE SURFAcE cLEANER
See Figures 24 - 25.
 Install the surface cleaner and connect the garden hoses
as described in the assembly section of this manual.
 Start the pressure washer as described earlier in this
manual.
 Walk slowly behind the surface cleaner, cleaning as you
go.
NOTE: If striping or swirling occurs, slow your pace.
If problem continues, see Troubleshooting later in this
manual.
OPERATiON
wARNiNg:
Striking any raised obstacle while using the surface
cleaner will damage the unit. If contact does occur and
causes vibration when operating the pressure washer,
stop and replace the spray bar. Continuing to operate
the unit without replacing the spray bar could result in
serious injury or damage to the unit.
NOTE: See figure 29 for the location of the spray bar.
LiFTiNg ANd MOviNg ThE PRESSURE
wAShER
See Figures 26 - 27.
NOTE: The pressure washer is heavy and may require two
people when lifting. Store all tools before moving.
To lift the pressure washer:
 Turn the pressure washer off. Point nozzle in a safe direc-
tion and pull trigger to release water pressure.
 Lift using the carrying handles.
To move the pressure washer:
 Turn the pressure washer off. Point nozzle in a safe direc-
tion and pull trigger to release water pressure.
 Tilt the machine toward you until it balances on the wheels
then roll the machine to the desired position.
NOTE: Use the garden hose storage strap to hold the coils
of the high pressure hose while transporting.
12 — English