Monti MBX Electric Mode D'emploi page 10

GB/US Operating instructions
OPERATION WITH VINYL ZAPPER
WARNING: Always unplug tool before attaching or removing accessories. Use only MBX
Others may be hazardous.
Vinyl Zapper
To loosen
MBX
To tighten
1. Steadily screw the vertical grip to the tool.
2. Assemble the Vinyl Zapper ® to the tool correctly with the specified MBX
®
When assembling the Vinyl Zapper , ALWAYS disconnect the tool from the electrical source.
After assembling the Vinyl Zapper ® , always store the Allen-key in a safe
place so that it is available for the next use.
3. Use the switch button to start the tool. For instructions, see "Switch Action",
above.
4. If necessary, run a trial operation of the Vinyl Zapper
®
make sure that the Vinyl Zapper is suitable for the surface condition.
5. Apply the tool to the surface with the proper pressure.
6. Move the tool right and left alternately and continuously, with a proper
speed on the flat surface. Do not allow the Vinyl Zapper
spot during use.
7. When not in use, store the tool and keep the surface of the Vinyl Zapper
clean for the next use.
WARNING: To reduce the risk of injury, always wear safety
goggles or glasses with side shields, gloves and dust mask. Refer strictly to the
"SAFETY RULES".
18
®
®
accessories.
®
Spindle
Adaptor
®
® Adaptor and the screw.
Efficient Direction
® before actual use, to
®
to stay in one
®
® ®
MBX Electric MBX Electric
INSTRUCTIONS FOR USE
Active Rotation
Corners
Phase 1
Phase 1: The belt works at full efficiency: Even a slight amount of pressure on the belt will remove a lot of material.
The bristle tips are sharp and straight.They don't break off.
Phase 2: The sharp bristle tips have become dull.The operator increased pressure on the belt to try to compensate
for the deceased efficiency of the slowly dulling tips.This caused the bristles to be bent backwards and
some of the bristle tips fell out.The belt is worn out and must be changed.
Phase 3: If you do not change the belt in Phase 2, the condition of the belt will be as shown in Phase 3.
Explanation: A traditional sanding disc is used up in a constant curve (see diagram) and you can see how much
it has been used and how much life remains. Conversely, in Phase 1, the belt operates with no visible wear for
a long time.The rapid progression to Phase 2 and then to Phase 3 is considered normal.
Tipp: If the belt begins to lose efficiency, check the belt bristles for wear. If wear has progressed to Phase 2,
change the belt. Increasing the pressure is incorrect use and will reduce the life of the belt. You can extend the life of the
belt in Phase 1 by re-sharpening the bristles, as described below.
Do not bear down excessively
= extended lifespan
Special Uses
Curves Edges
®
MBX working phases
Phase 2 Phase 3
Operating instructions GB/US
Observe correct
working position
Performance
®
MBX Phase 1
Phase 2
Phase 3
Lifespan
19